PRODUCT FEATURES
• Adjustable volume control (except Model RC520).
• Channels are selectable to allow more than one door chime set in same home.
• Sounds different tunes for front, second, and third doors.
• Optional Transmitter Model C521T available for second and third doors.
Wireless Door Chime
Battery Models
INSTALLATION
1. Open the chime button case by in-
serting a flat blade screwdriver into
the notch on the bottom and push to
open. Lift the front of the button up
and away from the back.
2. Insert the A23 battery into the but-
ton. The + side of the battery goes
up.
3. Insert “C” batteries into chime re-
ceiver. On Model RC520, pull white
face of chime off to insert batteries.
Test operation by pressing button.
If chime doesn’t operate, see trouble-
shooting section.
Before mounting the button outside,
hold it where you wish it to be and test
the operation. If it works, mount it there.
If it doesn’t work, see the troubleshoot-
ing section. If mounting to a metallic or
concrete surface, use a 1/8” to 1/4”
wood spacer between the back of the
button and the surface to increase the
range.
Wireless chime range can vary from 20
to 125 feet depending on the construc-
tion of your home. Wood or vinyl siding
are ideal. Steel, aluminum, brick or
stucco decrease the range.
Regulatory Information
The user is cautioned that changes or modifications not expressly approved
by the party responsible for regulatory compliance could void the user's
authority to operate this equipment.
Chime
Button
Battery+
QUICK START
1. Insert Battery into button.
2. Insert “C” Batteries into chime receiver.
3. Place Chime where you would like it.
4. Hold button where you would like to mount it. Push button and if chime works,
mount button. If not, read detail that follows.
To Next Page
Need help?
General
