Add button
Press this button to add the humidity and time; the humidity setting-up
procedure is 50%-55%-60%-65%-70%-75%-80%-85%-90%-95%.
Minus button
Press this button to reduce the humidity and time; the humidity setting-up
procedure is 50%-45%-40%-35%-30%-25%-20%.
Continuously dehumidifying mode button and indication light
Press this button to program into continuously dehumidifying mode, the
indication light will turn green, the default RH is 20% and the fan speed can be
adjusted manually.
Tank full indication light
The tank full indication light will turn on in red when the drainage tank is full. If
light is on, empty the water out of the drainage tank and make sure the tank is
positioned properly.
Humidity Level & Timer digit display
The digits indicator features 11 functions:
1. When the unit is plugged in, it will show “- -”, the machine will be in standby
state.
2. When press the power button, it will indicate the room humidity level.
3. When you set the humidity, it will indicate the humidity that you have
selected.
4. When you program the time for the unit to turn on and off, it will show the
hours.
5. Long press the timer button, it will indicate the room humidity level.
6. When the room temperature < 5℃, it will show ”TL”.
7. When the room temperature > 38℃, it will show “TH”.
8. When the room humidity < 20%RH, it will show “LO”.
9. When the room humidity > 92%RH, it will show “HI”.
10. If the temperature sensor got failure, it will show “E1”.
11. If the humidity sensor got failure, it will show “E2”.
To Next Page
Loading...
