3DRNX SLM BY BROOD
SAFETY REGULATIONS
NEVER ALLOW WATER TO COME INTO CONTACT WITH ANY OF THE ELECTRICAL PARTS OF
DRNX SLM: THERE IS A DANGER OF CREATING A SHORT CIRCUIT.
INTENDED USE
DRNX SLM is intended to be used in cafes, restaurants, and pantries. It dispenses liquid from any non-
pressurized container by drawing liquid, infusing it with atmospheric nitrogen and chilling it to 2°C. Do not
liquids that are above room temperature or that are unfiltered. It must only be operated by a trained person. The
appliance is not to be used by persons (including children) with reduced physical, mental or sensory abilities or
with scarce experience and/or expertise, unless they are supervised by a person responsible for their safety, or
they are instructed by this person on how to properly use DRNX SLM.
POWER SUPPLY
DRNX SLM must be connected to the power supply in accordance with its specifications. Only connect it with
the specified supply voltage.
POWER CORD
Never use DRNX SLM if the power cord is defective. Report any defects in the cord and/or plug to the service
provider immediately. Do not pass the power cord around corners, over sharp edges or over hot objects and keep
it away from oil. Do not use the power cord to carry or pull it. Do not pull out the plug by the power cord nor
touch it with wet hands. Do not let the power cord hang freely from tables or shelves.
FOR THE SAFETY OF OTHERS
Ensure that children cannot play with DRNX SLM and/or the packaging materials. Observe the warning and
safety instructions on the electrical components and in this manual. Improper use of DRNX SLM such as
opening it during operation, incorrectly operating it, or not following standard guidelines for operating electrical
equipment may lead to injury.
FIRE SAFETY PRECAUTIONS
In case of fire, use carbon dioxide (CO2) extinguishers. Do not use water or dry powder extinguishers.
SUITABLE LOCATION FOR OPERATION AND MAINTENANCE
DRNX SLM should be installed in accordance with the safety regulations in force at the time of installation.
Operate it in an environment between 13°C and 32°C. Make sure it is a dust-free environment. Avoid placing
open flames and/or incandescent objects near it to avoid melting or other damage to the dispenser housing. If the
dispenser has been exposed to such conditions, alert the service provider who will carry out a safety check.
STORING DRNX SLM
If DRNX SLM is to remain inactive for a long time, turn it o and unplug it. Store it in a dry place, out of reach
of children. Make sure the storage area is between 13°C and 40°C. Keep it protected from dust and dirt.
To Next Page
Loading...