4DRNX SLM BY BROOD
SAFETY REGULATIONS
GENERAL INFORMATION
REPAIRS / MAINTENANCE
In case of failure, problems or a suspected fault resulting from a fall, immediately remove the plug from the
power socket and alert the service provider or specialized technician. Never attempt to operate it if it is faulty.
Please report any fault to your service provider. Only the service provider and/or technician may carry out
servicing operations and repairs on DRNX SLM, unless otherwise informed. Any repair of the dispenser must
be done only when it is switched o and it is ascertained that there is no electric current. All spare parts must be
obtained from your service provider. Follow the service and maintenance instructions in this operation manual.
USE
DRNX SLM pulls any filtered liquid from an unpressurized container. It chills the liquid to 2°C and infuses it with
atmospheric nitrogen.
VISCOSITY OF LIQUID
Ensure that your beverage has been filtered in order not to clog the pre-filter or if that has been bypassed, not
to clog the machine. Thick liquids risk slowing down the liquid pump inside. DRNX SLM comes with a pre-filter
that is already fitted onto the beverage tube. If the pre-filter is not attached, you can risk damaging components
inside.
BEVERAGE CONTAINER
Any non-pressurized container can be used depending on what is required. We recommend using the designated
BROOD container (sold separately).
To Next Page