7
BATTERY INFORMATION
INSTALLING BATTERIES IN TRANSMITTER
1. Slide cover and lift to open BATTERY COMPARTMENT.
2. Insert two AAA batteries (not included), according to the polarities
indicated inside.
3. Replace cover.
4. Press RESET.
Note: Transmitter and monitor need to be reset within 60 seconds of each
other to synchronize units and establish a signal.
INSTALLING BATTERIES IN MONITOR
1. Slide cover and lift to open BATTERY COMPARTMENT.
2. Insert two AA batteries (not included), according to the polarities indicated inside.
3. Press RESET.
Note: Monitor and transmitter need to be reset within 60 seconds of each
other to synchronize units and establish a signal.
4. Replace cover.
8
GRILL ALERT
®
OPERATION
1. Connect MEAT PROBE CONNECTOR to TRANSMITTER SOCKET.
2. Turn on the transmitter by pressing and holding the POWER for two seconds.
Light will flash on LED.
3. Turn on the monitor by pressing and holding POWER for two seconds. The LCD
SCREEN will illuminate.
4. Check RECEPTION INDICATOR . It indicates whether or not you’ve
established signal connection by flashing.
IMPORTANT: If you have not established a signal connection, check
the following:
• Check synchronization of transmitter and monitor by pressing both RESET
buttons within 60 seconds of each other to synchronize units and establish
signal. On the monitor, RESET is located in the battery compartment, and on the
transmitter RESET is located on the outside of the battery compartment. (See
Location of Indicators illustration on pages 3-6.)
• Shorten the distance between transmitter and monitor. (Maximum transmission
range is 300 feet.)
• Check batteries and replace if necessary.
5. Select the meat you are cooking by pressing SELECT until your desired meat
appears on the display: Beef, Lamb, Veal, Hamburger, Pork, Turkey, Chicken
or Fish.
798314_INS_0713_Grill Alert_paginated.indd 15-16 7/24/13 3:09 PM
To Previous Page
Loading...
