11
OPERATING THE REMOTE
PAIRING THE REMOTE
The projector is primarily controlled through the included remote.
To pair the remote:
IMPORTANT: The distance between the remote and the projector
should be 6.5 feet or less.
1. Plug the power cord into the projector and the other end into
a wall outlet.
2. Power the projector on by pressing the on/off button on the
projector. Allow the projector a moment to startup
3. Install the (2) included AAA batteries in the remote control.
•Turn the remote control over and lcoate the battery door on
the rear of the unit.
•Press on the arrow on the remote door and slide in the
direction indicated by the arrow.
•Insert batteries negative (-) side first into the slots, pushing
the battery into the coil and then into the compartment.
IMPORTANT: Do not insert batteries positive (+) side first.
To Next Page
Loading...
