28
2. Scroll to "About this projector " on the settings menu.
3. Select "Factory data reset."
4. Select "Erase everything" and allow the projector a few
moments to erase all the data on the projector and restart.
TROUBLESHOOTING
The projected image is blurry.
• Adjust the focus wheel on the projector to fine-tune the picture.
•Check that the surface you are projecting on is smooth.
•Check that the projector’s lens is free of dust and debris.
The projected image is too small.
•Move the projector farther away from the projection surface.
The projected image is smaller on one side and larger on the other.
•Adjust the projector so the lens is facing your projection
surface at a 90° angle.
The projector is not powering on.
•Check that the power cable is firmly attached to the
projector's power port and the other end is securely plugged
into a wall outlet.
To Next Page
Loading...
