Brookstone “Bob” - Using the Timer

12
usIng the tImer
1. Remove the CLOCK BOTTOM and slide MODE LOCK ON/OFF to the
“On” position.
2. Press MODE until the Timer screen displays. The green LED backlight
illuminates for approximately four seconds.
3. Press SET. The minutes blink on the display.
4. Press
or incrementally until the desired minutes display (0-180).
Or press and hold
or to move at a faster rate.
5. Press SET again. The seconds blink on the display.
6. Press
or incrementally until the correct seconds display (0-59).
Or press and hold
or to move at a faster rate.
7. Press SET again to save your timer selection.
8. Press or to start the timer.
9. When the timer alarm sounds, press any button to shut the alarm off,
otherwise the alarm will stop automatically after one minute.
13
Note:
• The maximum countdown time is 180 minutes and 59 seconds.
• To deactivate the timer during countdown, press
or while in
the Timer screen. Press
or to reactive the timer.