11
Positioning the uAstro2
• Ensure that there is an allowance of more
than 45” behind the uAstro2 and more
than 20” in front of the uAstro2 to allow
the backrest to recline and the leg rest to
extend without obstruction during operation.
Preparation before use
Power On/Off
• Connect the power plug to the
electrical outlet.
• Turn on/off the main power switch
located at the back of the uAstro2
to power on/off the uAstro2.
Checking the backrest pad
• Lift the backrest upholstery to ensure
that there are no holes or tears on the
backrest pad.
• It is recommended that a carpet be
placed under the uAstro2 to prevent
scratching of the flooring and to reduce
noise level during operation.
• As the uAstro2 is heavy, please exercise
extra care not to damage the floor
surfaces when positioning it.
• Maintain a minimum distance of 3 feet
from AV devices such as a television or
radio to prevent signal interference.
• Use the uAstro2 only when it is placed
on an even, flat surface.
Caution
• Ensure the power cord is not placed
under the uAstro2.
• Ensure all switches are turned ‘OFF’
(including the main power switch)
before connecting the power plug
to an electrical outlet.
• Always check to ensure that there are
no holes or tears on the backrest pad.
Stop using the uAstro2 immediately if
you find even the slightest tear. Unplug
the uAstro2 and contact Brookstone
Customer Service at 866-336-3199.
45”
20”
Caution
Caution
To Next Page
Loading...
