13
How to recline the backrest
• To recline the backrest
Push and hold the [
] (Recline
button) until the backrest is at your
desired angle.
• To raise the backrest
Push and hold the [
] (Incline button)
until the backrest is at your desired angle.
Raising and lowering the leg rest
The leg rest can be raised for usage
or lowered for storage.
• To raise the leg rest
Press and hold the leg rest button [
]
until the leg rest is at the desired angle.
• To lower the leg rest
Press and hold the leg rest button [
]
until the leg rest is at the desired angle.
Leg rest extension and retraction
• Raise the leg rest until your legs
are placed at natural position.
• Stretch your legs to a comfortable
position. The leg rest will extend
or retract and stop at an
appropriate position.
Preparation before use
Sitting on the uAstro2
• The rollers are usually stored in the
upper part of the backrest. This position
is known as the ‘storage position’.
• If the rollers are not in the storage
position, simply reset by pressing the
power button on the controller before
sitting on the uAstro2.
To use the heat function
• Press [
] button to turn on/off the
heat function.
Caution
• Do not sit down on the chair with the leg
rest raised. Any sudden heavy weight on
the leg rest could cause damage to the
mechanism, or it may result in accident
or injury if the chair tips over.
• Ensure that the backrest returns to
its most upright position before sitting
down on the chair, then recline it
according to your preference.
To Next Page
Loading...
