11
sPeakeR oPeRaTIon
INSTALLING THE SPEAKER BATTERIES
1. You may insert batteries into the speaker as backup or if you prefer not to use
the SPEAKER POWER ADAPTER.
2. Turn the SCREWS located on the bottom of the speaker counterclockwise
and remove the BATTERY COMPARTMENT COVER.
3. Insert 8 D batteries (not included) according to polarity indicators inside
the compartment.
4. Replace the BATTERY COMPARTMENT COVER and tighten the SCREWS.
USING THE SPEAKERS WITH THE TRANSMITTER DOCK
1. If you are not using battery power, insert one end of the SPEAKER POWER
ADAPTER into DC 9V on the speaker, and the other end into an electrical outlet.
2. Turn on the power to your audio source.
Note: If the TRANSMITTER DOCK is connected to your audio source’s
variable-level output jacks, you may adjust the volume on your audio source.
If the TRANSMITTER DOCK is connected to your audio source’s fixed-level
output jacks, no volume adjustment is needed.
3. Slide CHANNEL SELECTOR on the transmitter from OFF to channel 1, 2 or 3.
The TRANSMITTER DOCK POWER INDICATOR illuminates.
4. Press POWER on the speaker. The SPEAKER POWER INDICATOR illuminates.
5. Turn the CHANNEL to 1, 2 or 3 on the speaker to the same channel selected
on the TRANSMITTER DOCK.
To Next Page
Loading...
