BROSA Force Measuring Pin
© 2021 BROSA AG, Tettnang, Germany English translation of the original
German document
14 / 15
...............................................................................................................................................................
................................
................................
................................
................................
...............................
............................................................................................................................................................
................................
................................
................................
................................
............................
3.5 Disposal
If the end of the service life is reached, the force measuring pin is to be disposed of in an
environmentally friendly way. Since the non-metallic components are a small proportion
compared to the mass of the force measuring pin, it can be recycled as a whole as scrap
steel. BROSA sensors are usually made of stainless steel and can be disposed of
accordingly.
If the sensor is stored before final disposal, an appropriate storage location is to be selected
which prevents harmful substances from entering the environment. If necessary, the sensor
must be cleaned.
WARNING! BROSA force measuring pins contain traces of environmentally hazardous
substances. This is also true of the impurities created during use. Contamination of the
environment by these substances is to be prevented.
To Next Page
Loading...