BROSA 0201 - Advice on the Safe Handling of BROSA Force Measuring Pins; Handling

To Next Page

To Previous Page

German document

9 / 15

BROSA Force Measuring Pin

...............................................................................................................................................................

................................

...............................

............................................................................................................................................................

................................

............................

3 Advice on the safe handling of BROSA force measuring

pins

WARNING! Non-compliance with the following instructions can lead to sensor damage

and/or impairment of measurement results. The analysis of an erroneous measurement can

result in personal injury or material damage.

WARNING! Despite their sturdy design, BROSA force measuring pins may not be used

for any other than the intended purpose (see. Section 1.1). With improper use, dangers to life

and limb of the user or third parties and/or impairment of the device in which the force

measuring pin is implemented or other material assets can be caused.

3.1 Handling

WARNING! BROSA sensors contain high-quality measurement electronics. Make sure

they are handled carefully.

- BROSA force measuring pins are delivered in transport-safe packaging. We

recommended that you remove the sensors from the package immediately prior to

installation.

- The mass of the force measuring pin is to be observed when selecting appropriate

handling equipment and/or lifting gear; it is indicated on the nameplate.

- BROSA force measuring pins must be secured against falling. Do not throw sensors!

- Use as a tool (e.g., impact, slotting or lever tool) is not permitted; it can cause

damage to the sensor and thus falsify the measurement results.

Main Page

BROSA 0201 - Advice on the Safe Handling of BROSA Force Measuring Pins; Handling

Table of Contents