Brose Allround - Page 31

Brose Display Allround | Operation and Control 31 | EN
NOTE
The Walk Assist function may only be used
when pushing the e-bike. If the e-bike wheels
have no contact with the ground when using
the Walk Assist, there is a risk of injury.
The Walk Assist cannot be activated in the
«OFF» assistance mode and in the menu and
Settings.
Changing the trip information view
Press the «Menu» key (Fig. B-b) on the display
unit to change between information about your
trip.
You can view the following information
› Range
› Time
› Route
› Trip time
› Average speed
› Maximum speed
› Total distance
NOTE
Some features may be deactivated depending
on the bike model. Detailed information is
available from your bike manufacturer and
your bike dealer.
5.4.2. Menu and Settings
Settings
Reset
Tripinformation
Menu
BACK
(4)
(2)
(1)
(3)
Fig. 6: Menu
The Menu and settings menu cannot be called
up whilst cycling.
A menu in the Brose «Allround» display/
control unit is arranged as follows:
(1) Title (always visible)
(2) Menu sub-point
(3) Back (last item, alternative to «Light» key
(Fig. B-c))
(4) Navigation bar
To call up the menu, stop or start the e-bike
and, with the bike stationary, do the following:
› Open the menu by pressing the «Menu»
key (Fig. B-b) for two seconds.
› Use the «Plus» (Fig. B-d) and «Minus»
keys (Fig. B-e) to navigate to the desired
item and call it up with the «Menu» key
(Fig. B-b).
Menu
You can obtain the following information via
the menu:
› Trip information (overview of full trip
information)
› Reset (all trip data)
› Settings