Brose E 41230 - Menu Navigation and Trip Data

Brose Display Allround | Operation and Control 31 | EN
NOTE: The Walk assist function may only be
used when pushing the e-bike. If the e-bike
wheels have no contact with the ground when
using the Walk assist, there is a risk of injury.
NOTE: The Walk assist cannot be activated in
the «OFF» assistance mode and in the menu
and Settings.
Changing the trip information view
Press the «Menu» key (Fig. A-b) on the display
unit to change between information about your
trip.
You can view the following information
› Range
› Time
› Route
› Trip time
› Average speed
› Maximum speed
› Total distance
NOTE: Some features may be deactivated
depending on the bike model. Detailed
information is available from your bike
manufacturer and your bike dealer.
5.4.2. Menu and Settings
Trip Information
Reset
Settings
BACK
Menu
(4)
(2)
(1)
(3)
Fig. 6: Menu
The Menu and settings menu cannot be called
up whilst cycling.
A menu in the Brose «Allround» display/
control unit is arranged as follows:
(1) Title (always visible)
(2) Menu sub-point
(3) Back (last item, alternative to «Walk
assist» key (Fig. A-f))
(4) Navigation bar
To call up the menu, stop or start the e-bike
and, with the bike stationary, do the following:
› Open the menu by pressing the «Menu»
key (Fig. A-b) for two seconds.
› Use the «Increase» (Fig. A-d) and
«Decrease» keys (Fig. A-e) to navigate
to the desired item and call it up with the
«Menu» key (Fig. A-b).
Menu
You can obtain the following information via
the menu:
› Trip information (overview of full trip
information)
› Reset (all trip data)
› Settings
Trip Information
Overview of all trip data
Reset Trip Information
To reset the display values in the trip
information, proceed as follows:
› To reset the display values in the trip
information, proceed as follows:
› Select «Reset» in the menu by pressing
the «Menu» key.
› If you would like to delete all trip
information, confirm this by pressing the
«Menu» key again.
190729_Brose_BDA-Allround-Multi.indd 31 29.07.2019 15:14:30