Brose E 41230 - Page 15

Brose Display Allround | Operation and Control 33 | EN
Light
Unit Format
Time Format
Battery Status
Clock
Shutdown Time
Default Settings
Custom. Assistance
BACK
System
(2)
(1)
(4)
(5)
(3)
(6)
(8)
(7)
Fig. 8: System Settings
You can make the following settings here:
(1) «Light»
» Activate automatic bike lighting
» Switch bike lighting on continuously
(2) «Unit format» The displayed units are
changed between «km/mi» and «km/h
/ mph».
(3) «Time format» (12h/24h) ): The display
times are switched between «12h / 24h».
(optional)
(4) «Battery status» Choose between
» Battery status as segments
» Battery status in percent (%)
(5) «Clock» (ss : mm) (optional)
» Press the «Menu» key. The hours
display flashes.
» Set the required hour using the
«Increase» and «Decrease» keys.
Conrm your entry with the «Menu» key.
» The minute display flashes. Set the
required minute using the «Increase»
and «Decrease» keys. Confirm your
entry with the «Menu» key.
» Exit the menu with the help of the «Walk
assist» key.
HINWEIS: Please note that not every
Brose Drive System features a «clock»
Module.
(6) «Shutdown time»: Define the automatic
switch-off time (1-20min) for your Brose
Drive System.
(7) «Custom.Assistance» Adjust your
assistance mode individually to your
needs.
(8) Reset «Default Settings»
» Select the «Default Settings» menu
point.
» Pressing the «Menu» key again resets
all settings to the delivery status.
190729_Brose_BDA-Allround-Multi.indd 33 29.07.2019 15:14:30