Brother 925D - User Manual

Questions and Answers

P
Patrick LongJul 26, 2025
Why do the threads keep breaking on my Brother 925D?
- D
  Donna JenkinsJul 26, 2025
  Thread breakage in your Brother Sewing Machine can occur due to several reasons: * **Improper threading:** Ensure the machine is threaded correctly. * **Thread tangled:** Check the spool pin and thread holders for any tangled thread and remove it. * **Thread tension too tight:** Refer to the 'Thread tension' section for adjustment. * **Needles incorrectly installed:** Make sure the needles are installed correctly. * **Wrong needle used:** Use the correct needle, Schmetz 130/705H is suggested.
W
watkinsnancyAug 3, 2025
What to do if my Brother Sewing Machine is skipping stitches?
- T
  Troy HunterAug 3, 2025
  Skipped stitches on your Brother Sewing Machine can happen for a few reasons: * **Needle bent or blunt:** Replace the needle with a new one. * **Needle incorrectly installed:** Ensure the needle is correctly installed. * **Wrong needle used:** Use the correct needle; Schmetz 130/705H is suggested. * **Improper threading:** Make sure the machine is threaded correctly. * **Presser foot pressure too loose:** Turn the pressure adjustment screw clockwise to increase the presser foot pressure.
K
Kevin GonzalesAug 10, 2025
How to prevent needles from breaking on my Brother 925D Sewing Machine?
- E
  Elizabeth CallahanAug 10, 2025
  Needle breakage on your Brother Sewing Machine can be attributed to: * **Needles bent, or needle tip blunt:** Replace the needle with a new one. * **Needles incorrectly installed:** Install the needle correctly. * **Material pulled forcibly:** Avoid pulling the material too hard when sewing.
C
Colleen RuizAug 18, 2025
Why is the fabric puckered when using my Brother Sewing Machine?
- A
  Andrew MurrayAug 18, 2025
  Fabric puckering when using your Brother Sewing Machine can be caused by: * **Thread tension too tight:** Decrease thread tension when sewing lightweight or fine material. * **Improper threading or tangled thread:** Ensure correct threading.