EasyManua.ls Logo

Brother 929D - Threading the left needle

Brother 929D
72 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
27
TABLE OF
CONTENTS
Chapter
1
Chapter
2
Chapter
3
Chapter
4
Chapter
5
Chapter
6
Chapter
7
Chapter
8
Chapter
9
Chapter
10
Chapter
11
Chapter
12
Chapter
13
Chapter
14
Chapter
15
Chapter
16
Chapter
17
Chapter
18
Chapter
19
Threading the left needle
Run the thread in the sequence illustrated, follow-
ing the orange color and the numbers next to each
threading point.
1 Pull the thread off the spool and directly up
through the thread guide on the thread tree
from back to front.
2 Pull the thread about an extra 15cm (6
inches) through the front of the thread tree.
3 Pass the thread through the proper thread
guide.
4 Slide and hold the thread tension release
button to the right, then pass the thread
through the tension disc which is in the
channel next to the orange tension adjust-
ment dial. Release the button.
5 Guide the thread down the channel and
across through the threading points next
to the orange color marks following the
numerical order in the accompanying illus-
tration.
6 Bring the thread down through the guide 7
above the needle and through the left
needle from front to back.
Enhebrado de la aguja
izquierda
Enhebre la aguja tal como ilustrado en la secuen-
cia, respetando el color naranja y los números
inscritos al lado de cada punto de enhebrado.
1
Saque el hilo del carrete y póngalo direc-
tamente por la guía de enhebrado del
árbol de enhebrado desde detrás a delan-
te.
2
Tire del hilo otros 15 cm aproximadamente
por la parte delantera del árbol de enhe-
brado.
3
Pase el hilo por la guía de hilo correspon-
diente.
4
Deslice y retenga el botón de liberación de
la tensión del hilo hacia la derecha, y pase
el hilo por el disco de tensión que es el
canal situado al lado del disco de ajuste de
la tensión naranja. Suelte el botón.
5
Guíe el hilo por el canal y pase el hilo a
través de los puntos de enhebrado al lado
de las marcas de color naranja siguiendo
el orden numérico de la ilustración.
6
Baje el hilo por la guía 7 por encima de la
aguja y por la aguja izquierda desde de-
lante a atrás.

Table of Contents

Related product manuals