Brother DCP-395CN - Page 184

USB cable scanning
177
12
For Touchscreen models 12
Setting the new default 12
a Press (Scan).
b Press Scan to Media.
c Press and choose your new setting. Repeat this step for each setting you want to change.
d After changing the last setting, press a or b to display Set New Default. Press Set New De fault.
e Press Yes to confirm.
f Press Stop/Exit.
Factory reset
12
a Press (Scan).
b Press Scan to Media.
c Press a or b to display Factory Reset. Press Factory Reset.
d Press Yes to confirm.
e Press Stop/Exit.