Brother DCP-9020CDW - Calibration

Routine maintenance
83
A
Calibration A
The output density for each colour may vary
depending on the machine’s environment,
such as temperature and humidity.
Calibration helps you to improve the colour
density.
a Press .
b Press Calibration.
c Press Calibrate.
d Press Yes to confirm.
e The machine will display Completed.
f Press .
You can reset the calibration parameters
back to the factory settings.
a Press .
b Press Calibration.
c Press Reset.
d Press Yes to confirm.
e The machine will display Completed.
f Press .
NOTE
• If an error message is displayed, press OK
and try again.
(For more information, see Error and
maintenance messages on page 86.)
• If you are using the Windows
®
printer
driver, the driver will get the calibration
data automatically if both
Use Calibration Data and
Get Device Data Automatically are
selected. The default settings are on (see
Software User's Guide).
• If you are using the Macintosh printer
driver, the printer driver will get the
calibration data automatically. If you want
to get calibration data manually, you must
perform the calibration using the
Status Monitor (see Software User's
Guide).