What to do if my Brother Printer prints garbage?
If your Brother Printer prints unexpectedly or prints garbage, pull out the paper tray and wait until the machine stops printing. Then turn off the machine’s power switch and disconnect from the power for several minutes. Also, check the settings in your application to make sure it is set up to work with your machine.
Why headers or footers do not print on my Brother Printer?
If headers or footers appear on the screen but do not print, it means there is an unprintable area on the top and bottom of the page. Adjust the top and bottom margins in your document to allow for this.
What to do for 'Toner Life End' message on Brother DCP-7030?
If your Brother All in One Printer indicates 'Toner Life End', gently shake the toner cartridge from side to side and reinstall it. This may help redistribute the toner and temporarily resolve the issue. The cause may be that the toner sensor detects that the cartridge is nearly empty, or the drum counter has reached its upper limit.
Why does my Brother DCP-7030 All in One Printer have black lines down the page or toner stains?
Black lines or toner stains may appear on printed pages due to several reasons. You can try the following: * Clean the corona wire inside the drum unit by sliding the green tab, ensuring to return it to its home position. * The toner cartridge may be damaged, consider replacing it with a new one. * The drum unit might be damaged, replace it if necessary. * The fuser unit could be smudged, in which case you should contact your Brother dealer for service.
How to fix vertical black line appears in copies with Brother All in One Printer?
Black vertical lines on copies are typically caused by dirt or correction fluid on the glass strip, or a dirty corona wire. Clean the scanner glass and the corona wire.
Why are the headers or footers not printing on my Brother DCP-7030 All in One Printer?
The headers or footers may not print because there's an unprintable area at the top and bottom of the page. Adjust the top and bottom margins in your document to accommodate this.
How to fix Scan Unable AF error on Brother All in One Printer?
If your Brother All in One Printer displays 'Scan Unable AF', replace the FB unit. Another possible cause is a main PCB failure, in which case you should replace the main PCB ASSY.
Why is my Brother All in One Printer printing garbage or unexpectedly?
To resolve this, pull out the paper tray and wait for the printer to stop. Then, turn off the printer and disconnect it from the power for a few minutes. Also, check your application settings to ensure they are correctly configured for your printer.
Why does my Brother DCP-7030 All in One Printer say 'Cooling Down'?
After the Brother All in One Printer has been on for a while, the message 'Cooling Down' may appear.
How to fix Cartridge Error on Brother DCP-7030?
If your Brother All in One Printer displays 'Cartridge Error', ensure the toner cartridge is properly attached. The error might be caused by a new toner detection lever malfunction.
Install and configure the software that translates PC data for your printer.
Using the TWAIN driver for scanning into applications supporting the standard protocol.
Utility for quick access to applications like Scan, Copy, PC-FAX, and device settings.
Steps to set up the machine for network scanning on Windows.
Using the application to configure machine settings remotely from a PC.
Sending documents as faxes from the PC using the Brother PC-FAX software.
Steps to send faxes directly from Mac applications.
Utility for quick access to Mac applications like Scan, Copy, OCR, and E-mail.
Configuring machine settings remotely from a Macintosh application.
General| Print technology | Laser |
|---|---|
| Maximum resolution | 2400 x 1600 DPI |
| Time to first page (black, normal) | 10 s |
| Print speed (black, normal quality, A4/US Letter) | 22 ppm |
| Scan to | |
| Grayscale levels | 256 |
| Input color depth | 48 bit |
| Maximum scan resolution | 9600 x 9600 DPI |
| Optical scanning resolution | 600 x 2400 DPI |
| Copier resize | 25 - 400 % |
| PC free copying | Yes |
| Maximum copy resolution | 600 x 600 DPI |
| Maximum number of copies | 99 copies |
| Copy speed (black, normal quality, A4) | 22 cpm |
| Total input capacity | 250 sheets |
| Total output capacity | 100 sheets |
| Internal memory | 16 MB |
| Card reader integrated | - |
| Sound power level (standby) | 30 dB |
| Sound pressure level (printing) | 51 dB |
| Display | LCD |
| Product color | White |
| Market positioning | Home & office |
| Paper tray media types | Bond paper, Plain paper, Recycled paper, Transparencies |
| Non-ISO print media sizes | Executive |
| ISO A-series sizes (A0...A9) | A4, A5, A6 |
| ISO B-series sizes (B0...B9) | B6 |
| Maximum ISO A-series paper size | A4 |
| Multi-Purpose Tray media weight | 60 - 163 g/m² |
| Standard interfaces | USB 2.0 |
| Dimensions (WxDxH) | 428 x 396 x 257 mm |
| All-in-one functions | Copy, Scan |
| Color all-in-one functions | No |
| Power consumption (standby) | 80 W |
| Power consumption (PowerSave) | 10 W |
| Power consumption (average operating) | 460 W |
| Package depth | 510 mm |
| Package width | 550 mm |
| Package height | 454 mm |
| Package weight | 13400 g |
| Maximum duty cycle | - pages per month |
| Sustainability certificates | ENERGY STAR |
Weight and Dimensions| Depth | 396 mm |
|---|---|
| Width | 428 mm |
| Height | 257 mm |
To Next Page
