Brother DCP-7030 - Using the BR-Script3 Driver (MFC-7840 W Only) (Post Script 3 Language Emulation Printer Driver)

Printing and Faxing
130
8
Using the BR-Script3 Driver (MFC-7840W only)
(Post Script
®
3 ™ language emulation printer driver) 8
Note
• To use the BR-Script3 printer driver, you need to set the Emulation to BR-Script 3 by using the
control panel before connecting the interface cable. (See Printer Emulation Support (MFC-7840W only)
on page 117.)
• The BR-Script3 printer driver does not support the PC-Fax Sending.
• For network users, see the Network User’s Guide for installation steps.
You need to install the BR-Script3 printer driver using the following instructions.
Note
If you use a USB cable and Mac OS
®
, only one printer driver for a machine can be registered in Printer
Setup Utility (Print Center for Mac OS
®
10.2.X users). If a Brother Laser driver is already listed in the
Printer list, you will need to delete it and then install the BR-Script3 printer driver.
 For Mac OS
®
X 10.2.x to 10.4.x
a Choose Applications from the Go menu.
b Open the Utilities folder.