Secure Network Access
Your machine’s default password is initpass. We
recommend you change it to protect your machine
from unauthorised access.
NOTE
• The Reference Guide for these models is available on the
enclosed installation disc.
• Most of the illustrations in this Quick Setup Guide show the
MFC-J1300DW.
• Save all packing materials and the box in case you must ship your
machine.
• You must purchase the correct interface cable for the
interface you want to use.
USB cable
We recommend using a USB 2.0 cable (Type A/B) that is no more
than 2 metres long.
Ethernet (Network) cable (MFC-J1300DW only)
Use a straight-through Category 5 (or greater) twisted-pair cable
for 10BASE-T or 100BASE-TX Fast Ethernet Network.
2
Load paper in the paper tray
For more information about paper handling and sizes, see the Reference Guide.
1
Unpack the machine and check the components
The components included in the box may differ depending on your country.
Remove the protective tape or film covering the machine.
Follow the touchscreen
instructions to unpack and install
the ink cartridges. Close the ink
cartridge cover. The machine will
prepare the ink tube system for
printing.
NOTE
Thersttimeyouinstallasetofink
cartridges the machine will use an
amountofinktolltheinkdelivery
tubes for high quality printouts. This
process will only happen once.
Open the ink cartridge cover.
After turning the machine on, you may need to set your country or language (depending on
your machine).
If required, follow the touchscreen instructions.
NOTE
You can adjust the control panel angle to read the
touchscreen more easily.
Quick Setup Guide
DCP-J1100DW / MFC-J1300DW
Read the Product Safety Guide first, then read this Quick Setup Guide
for the correct installation procedure.
3
Connect the power cord
5
Install the inbox ink cartridges
4
Select your country or language
(Initial setup only)
D011R6001-00
UK
Version 0
Inbox Ink Cartridges*
• Black
• Yellow
• Cyan
• Magenta
*
Inbox ink cartridges contain the
following yield of replacement
High Yield cartridges:
- Black: approx. 90% yield
- Others: approx. 80% yield
uu
Reference Guide: Supply
Specications
Quick Setup Guide
Product Safety Guide
Power Cord
Brother Installation Disc
1. Press [Settings] > [All Settings] >
[Initial Setup] > [Local Language].
2. Press your language.
3. Press .
8
Select your language
(if needed and only for
certain models)
9
Connect the telephone line cord
(MFC model only)
If you are not using your machine as a fax, go to
10
.
For more information on using the fax feature, see the Online User’s Guide.
The latest manuals are available at the Brother Solutions Center:
support.brother.com/manuals
Watch our FAQ videos for help
with setting up your Brother
machine.
support.brother.com/videos
6
Set the date and time
Follow the touchscreen instructions to set the date and time.
Quickly shake just the black
ink cartridge horizontally
15 times as shown, before
inserting it into the machine.
Open the output paper tray
cover a. Fan the paper well and load it in the tray.
Close the output paper tray cover, and
then slowly push the tray completely
into the machine.
Adjust the paper guides.
NOTE
Pull out the paper support a, and unfold
thepapersupportapb so that the
printed pages do not fall.
When the machine has finished the initial cleaning
process, follow the touchscreen instructions to
configure the machine’s settings.
• Set Brother LCD Message defaults
• Check print quality
• Print the installation sheet
7
Machine settings
1
2
([DPSOHIRU8.
(Example for UK)
To Next Page
Need help?
General
Weight and Dimensions
