Brother DCP-J125 - Page 197

Printing photos from a memory card or USB Flash memory drive
39
8
Remove Red-Eye 8
The machine detects eyes in your photos and
will attempt to remove red-eye from your
photo.
Note
There are some cases when red-eye may
not be removed.
• When the face is too small in the
image.
• When the face is turning too far up,
down, left or right.
a Make sure you have put the memory
card or USB Flash memory drive in the
correct slot.
Press (PHOTO CAPTURE).
b Press a or b to choose
Enhance Photos.
Press OK.
c Press d or c to choose your photo.
Press OK.
d Press a or b to choose
Remove Red-Eye.
Press OK.
 When Remove Red-Eye is
successful, the photo with the effect
is shown. The adjusted part is shown
in a red frame.
 When Remove Red-Eye is
unsuccessful,
Unable to Detect. is shown.
Press OK.
Note
Press # to try Remove Red-Eye once
again.
e Press OK and enter the number of
copies you want using the dial pad.
f Do one of the following:
 Press OK and change the print
settings. (See PhotoCapture
Center™ print settings on page 42.)
 If you do not want to change any
settings, press Colour Start to print.
Monochrome 8
You can convert your photo to monochrome.
a Make sure you have put the memory
card or USB Flash memory drive in the
correct slot.
Press (PHOTO CAPTURE).
b Press a or b to choose
Enhance Photos.
Press OK.
c Press d or c to choose your photo.
Press OK.
d Press a or b to choose Monochrome.
Press OK.
e Press OK and enter the number of
copies you want using the dial pad.
f Do one of the following:
 Press OK and change the print
settings. (See PhotoCapture
Center™ print settings on page 42.)
 If you do not want to change any
settings, press Colour Start to print.
Sepia 8
You can convert the colour of your photo to
sepia.
a Make sure you have put the memory
card or USB Flash memory drive in the
correct slot.
Press (PHOTO CAPTURE).
b Press a or b to choose
Enhance Photos.
Press OK.