19
For Wireless Network Users
Wireless Network
11
One-push setup using
WPS or AOSS™
(Windows
®
,
Macintosh and mobile devices)
a Confirm your wireless access point/router has
the WPS or AOSS™ symbol as shown below.
b Place the Brother machine within range of your
WPS or AOSS™ access point/router. The
range may differ depending on your
environment. Refer to the instructions provided
with your access point/router.
c Press .
Press s or t to display WPS/AOSS.
Press WPS/AOSS.
When Enable WLAN? is displayed, press Yes
to accept.
This will start the wireless setup wizard.
To cancel, press No.
d When the Touchscreen instructs you to start
WPS or AOSS™, press the WPS or AOSS™
button on your wireless access point/router (for
more information, see the instructions provided
with your wireless access point/router), and
then press OK on your machine.
This feature will automatically detect which
mode (WPS or AOSS™) your wireless access
point/router uses to configure your machine.
Press OK.
Wireless setup is now complete.
The Wi-Fi LED on the control panel
lights up, indicating that the machine’s
Network I/F is set to WLAN.
To install MFL-Pro Suite, continue to
step 12.
For Windows
®
users:
Page 22
For Macintosh users:
Page 25
If your wireless access point/router supports
WPS, you can also configure your machine using
the PIN (Personal Identification Number) Method.
uuSoftware and Network User’s Guide
If the connection failed, check the error code on
the printed report and refer to Troubleshooting
on page 20.
For mobile device users:
• Connect your mobile device to a wireless
access point/router using a Wi-Fi connection.
• Download and install Brother iPrint&Scan
(Android™/iOS/Windows
®
Phone) from your
mobile device’s application download site. You
can also use AirPrint (iOS) with this machine.
• To download the User’s Guide for the
application you are using (Brother
iPrint&Scan/AirPrint), visit the Brother
Solutions Center at
http://solutions.brother.com/
and click Manuals
on your model’s page.