5
d Fan the stack of paper well to avoid paper jams
and misfeeds.
e Gently put the paper into the paper tray print
side down and top edge first. Check that the
paper is flat in the tray.
f Gently adjust the paper width guides to the
paper with both hands. Make sure that the
paper width guides touch the edges of the
paper.
g Close the output paper tray cover.
h Slowly push the paper tray completely into the
machine.
i While holding the paper tray in place, pull out
the paper support a until it clicks, and then
unfold the paper support flap b.
6
Check the print quality
a When the preparation process has finished, the
Touchscreen shows Load Paper and
Press Start.
Press Start.
b Check the quality of the four colour blocks on
the sheet. (black/yellow/cyan/magenta)
c If all lines are clear and visible, press Yes to
finish the quality check and go to the next step.
If lines are missing, press No and follow the
steps on the Touchscreen.
Always make sure that the paper is not curled or
wrinkled.
Be careful that you do not push the paper in too
far; it may lift at the back of the tray and cause
paper feed problems.
OK
Poor
To Next Page
Loading...
