Home > Paper Handling > Load Paper > Paper Settings > Change the Check Paper Setting
Change the Check Paper Setting
If this setting is set to [On] and the paper tray is removed or you load paper in the MP Tray, the LCD displays a
message asking if you want to change the Paper Size and Paper Type settings.
The default setting is [On].
>> DCP-T520W/DCP-T525W/DCP-T720DW/DCP-T725DW/DCP-T820DW/DCP-T825DW
>> MFC-T920DW/MFC-T925DW
DCP-T520W/DCP-T525W/DCP-T720DW/DCP-T725DW/DCP-T820DW/DCP-T825DW
1. Press Menu.
2. Press a or b to make your selections:
a. Select [General Setup]. Press OK.
b. (DCP-T820DW/DCP-T825DW) Select [Tray Setting]. Press OK.
c. Select [Check Paper]. Press OK.
d. Select [On] (or [Off]). Press OK.
3. Press Stop/Exit.
MFC-T920DW/MFC-T925DW
1. Press Settings.
2. Press a or b to make your selections:
a. Select [General Setup]. Press OK.
b. Select [Tray Setting]. Press OK.
c. Select [Check Paper]. Press OK.
d. Select [On] or [Off]. Press OK.
3. Press Stop/Exit.
Related Information
• Paper Settings
Related Topics:
• Load Cut-Sheet Paper or Photo 2L Paper in the Paper Tray
• Load Photo Paper in the Paper Tray
• Load Envelopes in the Paper Tray
• Error and Maintenance Messages
47
To Next Page
Loading...
