Brother GTX pro Bulk - Page 28

17
Setu
p
of the
p
rinte
r
6.
Connect the flat cable by fitting it with the core.
Fit the claw by pushing the core until it clicks into place.
Leave a slack to avoid interference with the resin cover.
7.
Hook the two claws of the resin cover to mount the cover (d).
Tuck the extra flat cable as shown in the illustration.
8.
Remove four caps of the head.
Check that the head and the marker of each tube are matched
and connect the tubes one by one from back to front of the
machine by rotating the nut until it stops.
IMPORTANT
Do not rotate the nut as illustrated in (e). It could
disconnect the tube and leak the contained ink.
Be sure to remove the caps attached to the
head before connecting.
X0379
(d)
X0377
M4
4
3
2
1
M
C
Y
K
C3
Y2
Bk1
M4
C3
Y2
Bk1
(e)
X0380