To Next PageTo Next PageWhat to do when my Brother HL-5240L shows 'Memory Full'?
If your Brother printer displays a 'Memory Full' error, press 'Go' to print the remaining data in the printer memory. Alternatively, cancel the print job to delete the remaining data. To prevent this issue, reduce the complexity of your document or decrease the print resolution. You can also add more memory to the printer.
What to check if my Brother Printer is not printing?
If your Brother printer is not printing, ensure the printer cable is securely connected. Also, verify that you have selected the correct printer driver on your computer.
What to do if my Brother Printer says 'No Paper'?
If your Brother printer displays a 'No Paper' error, ensure the paper tray is not empty and is correctly installed. If it contains paper, verify that the paper is straight and not curled. Try removing the paper, turning the stack over, and reinserting it. Reduce the amount of paper in the tray. Ensure that you are using paper that meets Brother’s recommended specifications and that the loaded paper size matches your current driver settings.
How to fix 'Print Overrun' on my Brother HL-5240L Printer?
If your Brother printer displays a 'Print Overrun' error, first, try pressing 'Go' to print the remaining data in the printer memory. If that doesn't work, cancel the print job to delete the remaining data. You can also reduce the complexity of your document or lower the print resolution. As additional steps, consider setting page protection to AUTO via the Windows driver or Remote Printer Console, and adjust the Graphics mode, TrueType mode, and Use Printer TrueType Fonts settings in the Windows driver.
How to resolve 'Print Overrun' error on Brother Printer?
If your Brother printer displays a 'Print Overrun' error, first, try pressing 'Go' to print the remaining data in the printer memory. If that doesn't work, cancel the print job to delete the remaining data. You can also reduce the complexity of your document or lower the print resolution. As additional steps, consider setting page protection to AUTO via the Windows driver or Remote Printer Console, and adjust the Graphics mode, TrueType mode, and Use Printer TrueType Fonts settings in the Windows driver.
How to fix 'Front Cover is Open' error on Brother Printer?
If your Brother printer indicates that the front cover is open, ensure that you close the front cover of the printer.
How to fix 'Incorrect Paper Size for Auto DX' on Brother HL-5240L Printer?
If your Brother printer displays 'Incorrect Paper Size for Auto DX', press 'Go' or 'Job Cancel'. Then, either set the correct paper size you intend to use or load paper of the same size selected in your current driver settings.
What to do if my Brother HL-5240L says 'Fuser Cover is Open'?
If your Brother printer indicates that the fuser cover is open, close the fuser cover located behind the back cover of the printer.
What to do if my Brother Printer shows an error writing to LPT1?
General| Printer Type | Laser |
|---|---|
| Connectivity | USB 2.0, Parallel |
| Monthly Duty Cycle | 30, 000 pages |
| Paper Capacity | 250 sheets |
| Duplex Printing | Manual |
| Processor | 200 MHz |
| Memory | 8 MB |
| Maximum Paper Size | Legal |
| Print Resolution | 1200 x 1200 dpi |
