4
4
Print a test page
a Make sure that the printer power switch is off.
Connect the AC power cord to the printer.
b Turn on the printer power switch.
c Unfold support flap1.
d After the printer has finished warming up, the
LCD shows READY.
e Press Go. The printer prints a test page. Check
that the test page has printed correctly.
5
Setting your language on
the control panel
a Press + until the LCD shows SETUP.Press
Set.
SETUP
b Press Set again.
LANGUAGE
c Press + or – to choose your language. Press
Set to accept.
=ENGLISH
Now go to
Go to the next page to install the printer driver.
IMP
RTANT
DO NOT connect the interface cable yet.
Note
This function will not be available after the first
print job you send from your computer.
To Next Page
Loading...
