Level 1 Level 2 Level 3 Level 4 Descriptions
WLAN TCP/IP APIPA
- Allocate the IP address from the link-local
address range automatically
1
.
IPv6
- Enable or disable the IPv6 protocol.
Setup Wizard
- - Configure the wireless network settings using
the setup wizard.
WLAN Assistant
- - Configure your wireless network settings using
the Brother installation disc.
WPS
- - Configure your wireless network settings using
the one-button push method.
WPS w/PIN Code
- - Configure the wireless network settings using
WPS with a PIN code.
WLAN Status Status
- Display the wireless Ethernet link status.
Signal
- Display the signal condition.
Channel
- Display the channel in use when Status is
Active.
Speed
- Display the connection speed when Status is
Active.
SSID
- Display SSID.
Comm. Mode
- Display the current Communication mode.
MAC Address
- - Display the MAC address of the machine.
Set to Default
- - Restore wireless network settings of your
machine to the factory settings.
WLAN Enable
- - Turn the wireless interface on or off.
Wi-Fi Direct Push Button
- - Configure your Wi-Fi Direct network settings
using the one-button push method quickly.
PIN Code
- - Configure your Wi-Fi Direct network settings
using WPS with a PIN code quickly.
Manual
- - Configure your Wi-Fi Direct network settings
manually.
Group Owner
- - Set your machine as the Group Owner.
Device Info. Device Name
- View your machine's device name.
SSID
- Display the Group Owner's SSID.
IP Address
- Display your machine's IP Address.
Status Info. Status
- Display the Wi-Fi Direct network status.
Signal
- Display the current Wi-Fi Direct network signal
strength.
When your machine acts as Group Owner, the
LCD always displays Strong.
Channel
- Display the channel in use when the Status is
G/O Active or Client Active.
Speed
- Display the connection speed when the Status
is G/O Active or Client Active.
I/F Enable
- - Enable or disable the Wi-Fi Direct connection.
Network
Reset
- - - Restore all network settings of your machine to
the factory settings.
1
On connection to the network, if the machine's ‘Boot Method’ is ‘Auto’ the machine will attempt to set the IP address and Subnet Mask
from a boot server such as DHCP. If a boot server cannot be found, an APIPA IP address will be allocated, such as 169. 254. [001-254].
[000-255]. If the ‘Boot Method’ of the machine is set to ‘Static’ you must manually enter an IP address from the machine's control panel.
225