7. Close the machine's top cover.
8. Reset the belt unit counter by following the next section.
IMPORTANT
• To avoid print quality issues or damage to the machine, DO NOT reset the belt unit counter unless you
are replacing the belt unit.
• Using non-genuine Brother supplies may affect the print quality, hardware performance, and machine
reliability.
Reset the Belt Unit Counter (HL-L3210CW/HL-L3230CDW)
1. Make sure the machine is turned on.
2. Make sure the machine's cover is closed.
3. Press OK and a at the same time.
4. Press a or b to display the [Belt] option, and then press OK.
5. Select [Reset] to reset the belt counter.
Reset the Belt Unit Counter (HL-L3270CDW)
1. Make sure the machine is turned on.
2. Press and hold for about five seconds.
3. Press [Belt].
4. Press [Yes].
Related Information
• Replace Supplies
Related Topics:
• Error and Maintenance Messages
• Improve the Print Quality
271
To Next Page
Loading...
