8. If you selected [WEP] for Encryption Type, enter the WEP key, and then press [OK].
• For more information about how to enter text, see the User's Guide.
• Your Brother machine supports the use of the first WEP key only.
9. To apply the settings, press [Yes]. To cancel, press [No].
10. The machine will attempt to connect to the wireless device you have selected.
If your wireless device is connected successfully, the machine's LCD displays [Connected].
You have completed the wireless network setup. To install drivers and software necessary for operating your
device, insert the Brother Installation CD-ROM to your computer or go to your model's Downloads page on the
Brother Solutions Center at
support.brother.com to install drivers and software necessary for operating your
device.
Related Information
• Configure Your Machine for a Wireless Network in Ad-Hoc Mode (For IEEE 802.11b/g/n)
• How to Enter Text on Your Brother Machine
• Wireless LAN Report Error Codes
104
To Next Page
Loading...
