Brother Homelock 1034D - How to Adjust; Height of Needle Bar

-2-
II 
  !"#$%&
1. Raise the needle to its highest position.
2. Loosen the screw on the needle bar.
3. Position the needle bar so that the clearance between the point of the needle and the surface of the
needle plate is as follows:
11.3 ~ 11.9 mm
NOTE: When making this adjustment, keep the needle bar at its highest position by holding the handwheel.
The long groove of the needle should face toward you.
PARTS CODE FOR GAUGE: X77402001
www.promelectroavtomat.ru