Error code 8E01Error code 8E01
Upon fax reception, the paper size setting is the one other than A4, Letter.Upon fax reception, the paper size setting is the one other than A4, Letter.
Error code 8E02Error code 8E02
Detected that the size of paper set in the paper tray was over 10 mm shorter than letter sizeDetected that the size of paper set in the paper tray was over 10 mm shorter than letter size
during receiving fax or printing list/report.during receiving fax or printing list/report.
Error code 9002Error code 9002
When printing from the paper tray, the size of paper set in the paper tray does not match theWhen printing from the paper tray, the size of paper set in the paper tray does not match the
size specified by the driver.size specified by the driver.
Size mismatchSize mismatch
Fax received. Set correct paper size in menu.Fax received. Set correct paper size in menu.
Size mismatchSize mismatch
Reload correct paper, then press Reload correct paper, then press Start.Start.
<User Check><User Check>
•• Select Select A4 or letA4 or letter size ter size in the pin the paper setaper setting.ting.
SStteepp CCaauussee RReemmeeddyy
11
Paper printing position actuatorPaper printing position actuator
caught in sections of thecaught in sections of the
machinemachine
Reattach the paper printing position actuator.Reattach the paper printing position actuator.
22
Paper feed/paper printingPaper feed/paper printing
position sensor failureposition sensor failure
Replace the paper feed/paper printing positionReplace the paper feed/paper printing position
sensor PCB ASSY.sensor PCB ASSY.
33 MMaaiin n PPCCB B ffaaiilluurree RReeppllaacce e tthhe e mmaaiin n PPCCB B AASSSSYY..
Size MismatchSize Mismatch
Reload correct paper, then press Reload correct paper, then press Start.Start.
<User Check><User Check>
•• Change the drChange the driver settiiver setting to match the sizng to match the size of the paper set in the pae of the paper set in the paper trayper tray..
SStteepp CCaauussee RReemmeeddyy
11
Paper printing position actuatorPaper printing position actuator
caught in sections of thecaught in sections of the
machinemachine
Reattach the paper printing position actuator.Reattach the paper printing position actuator.
22
Paper feed/paper printingPaper feed/paper printing
position sensor failureposition sensor failure
Replace the paper feed/paper printing positionReplace the paper feed/paper printing position
sensor PCB ASSY.sensor PCB ASSY.
33 MMaaiin n PPCCB B ffaaiilluurree RReeppllaacce e tthhe e mmaaiin n PPCCB B AASSSSYY..
To Next Page
Loading...
