53
Ch. 3 Functions
Functions
Frame function (FRAME)
With the Frame function, you can choose from a
variety of frames and highlights for emphasizing
certain parts or all of the text in your label. For
samples of the available frame settings, refer to
page 98. When any setting other than OFF is
selected for the text at the cursor’s current posi-
tion, the Frame indicator at the top of the dis-
play comes on. The lines on the right side of the
indicator, starting from the top, show if the
Frame setting is applied to the entire text, the
block or the line.
To change the setting for the Frame function:
1 Hold down d and press 1, 2 or 3.
2 Press j or k until FRAME is displayed.
The setting for the text at the cursor’s cur-
rent position is shown on the left side of the
display and a sample can be seen on the
right side.
3 Press m or g until the desired setting is
displayed.
4 Press n to apply the setting.
Text Alignment function
(ALIGNMENT)
You can choose to align the text in one of four
ways:
NOTE
This step may be skipped if settings for several for-
mat functions are being applied at the same time.
Length Margin Font Width Size
1 2 3 4 5 6 7 8 9
A B C D E F K
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
R
R
R
R
R
R
G
H
I
J
L
M
NO
AUTO 1.10 HELSINKI A AUTO
<<< P-touch >>>
1
:
_
Length Margin Font Width Size
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
K
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
R
R
R
R
R
R
G
H
I
J
AUTO 1.10 HELSINKI A AUTO
07/13
FRAME
OFF
L
M
N
NOTE
☞
Even if a frame setting has already been applied
to either a line in the current text block (if the
Block Format or the Global Format Frame func-
tion is being set) or a block in the current text (if
the Global Format Frame function is being set),
all frames will be applied and printed.
☞
To return the function to its default setting (the
square frame OFF), press the space bar.
☞
To return to the text without changing the for-
matting, press
e
(OR hold down
d
and
press
1
,
2
or
3
).
NOTE
To apply several format settings at the same time,
continue pressing j or k to select the function,
then pressing m or g to select the desired setting.
Press n only after the necessary functions have
been set.
LEFT
CENTER
RIGHT
JUSTIFY
To Next Page
Loading...
