6. (Windows only) Select [Change the Firewall port settings to enable network connection and continue with the installation.(Recommended)], and then click [Next].
7. Prepare a USB cable. Select [Yes, I have a USB cable to use for installation.].
WPS Users Only
If you want to use WPS (Wi-Fi Protected Setup™), select [No, I do not have a USB cable]. Follow the on-screen instructions to complete the software installation, and then go to step 13.
Windows Mac
8. Select the SSID (Network Name) you confirmed previously, and then click [Next].
Windows Mac
9. When the installation confirmation screen appears, make sure the check box is selected, and then click [Next].
10. Confirm that the SSID (Network Name) is correct, and then select [Yes].
Windows Mac
11. Follow the on-screen instructions to complete the software installation.
When the installation is complete, click [Finish] to close the installer window.
12. When the printer is connected to your wireless router/access point, the printer’s Wi-Fi LED becomes lit.
13. Make sure that the Editor Lite LED is off. Start the P-touch Editor and select the printer from the list.
14. You can now edit and print labels wirelessly from your computer.
[ Back To Top ]
Set up the wireless connection manually with the printer driver installed (For Windows)
To connect your printer to a wireless network, you must use the supplied AC adapter or Li-ion battery. If your Brother printer is powered by alkaline or Ni-MH batteries, you cannot connect it to a
wireless network.
To Next Page
Loading...
