————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————
1
9
Thread the machine by guiding the thread
along the path indicated by the number
on the machine.
0
Make sure you guide the thread through
the thread take-up lever from right to left
as shown in the following illustration.
1 Thread take-up lever
● If the thread take-up lever is lowered, the
upper thread can not be wrapped around
the thread take-up lever. Make sure you
raise the needle by turning the handwheel
toward you (counterclockwise) so that the
mark on the wheel points up.
a
Put the thread behind the guide above the
needle.
• The thread can easily be passed behind the
needle bar thread guide by holding the
thread in your left hand, then feeding the
thread with your right hand.
1 Needle bar thread guide
b
Lower the presser foot lever.
c
Make sure that the mark on the wheel
points up as shown in the following
illustration.
1 Mark on the wheel
To Next Page
Loading...
Need help?
General
