5
General Precautions
• Be sure the machine is always placed on a level, stable surface.
• Lift the machine by grabbing the specified areas.
• Be sure to meet the power requirements specified for this machine.
• Keep the machine and its accessories out of direct sunlight and extremely dusty places.
• Do not expose the machine or any of its accessories to extremely high or extremely low temperatures or high
humidity.
• Do not try to disassemble the machine or any of its accessories.
• When connecting and disconnecting the cables, always be sure to grab only the connector.
• Store the draft sheets, the ID label sheets, and the cleaning sheets in their packages. Do not use folded or
damaged draft sheets, ID label sheets, or cleaning sheets.
• Never look at the flash which may leak from the stamp compartment.
• Do not touch the machine’s internal parts since they become extremely hot after the machine has been used for
a long time.
• Do not leave the machine for a long period of time with the ink ribbon compartment cover or stamp
compartment cover open or the xenon lamp unit or draft tray uninstalled.
• Do not touch any of the machine’s internal sensors.
• Avoid using the machine in extremely dusty places. Keep it out of both direct sunlight and rain.
• Do not expose the machine to extremely high temperature or humidity.
• Do not leave any rubber or vinyl on the machine for an extended period of time. Doing so may cause staining.
• Do not clean the machine with alcohol or other organic solvents. Only use a soft, dry cloth.
• Do not put any foreign objects into or heavy objects on the machine.
• To avoid injures, do not touch the cutter’s edge.
• Do not touch the print head, which becomes very hot when SC-2000USB is used. Even after the machine is
turned off, the print head remains hot for some time.
• Use only the power supply cord designed exclusively for this machine. Use of any other cord will void the
warranty.
• Use only the attached interface cables for this machine. Use of any other cable will void the warranty.
• When the machine is not being used for a long period of time, disconnect the power supply cord.
• Do not try to disassemble the SC-2000USB.
System Requirements
Computer Requirements
Check that your system meets the following requirements.
• OS: Windows
®
XP / Windows Vista
®*1
/ Windows
®
7
*1
• Interface: USB port (USB Spec 1.1 or 2.0 protocol)
Serial port (9-pin, RS-232C, supports 115,200 bps)
• Hard Drive: Over 70MB of available space
*2
• Memory: Windows
®
XP: 128 MB or more
Windows Vista
®
: 512 MB or more
Windows
®
7: 1 GB (32-bit) or 2 GB (64-bit) or more
• Monitor: SVGA, high color or higher graphics card
• Others: CD-ROM drive, pointing device
*1
The PC should meet Microsoft
®
's recommendations for the OS installed.
*2
Required available space when installing the software with all of the options.
To Next Page
Loading...
