What to do if a draft sheet or ID label sheet does not feed into the ID label slot on my Brother Stampcreator PRO SC2000USB Label Maker?
First, ensure the ID label sheet is inserted as far as possible into the ID label slot. Next, check that the ID label sheet is inserted so the words 'ID LABEL' can be read. Also, verify that the ID label is the correct size. Finally, clean the ID label rollers.
What to do if a draft sheet was not fed from the draft tray of my Brother Stampcreator PRO SC2000USB?
Verify that a draft sheet has been loaded correctly in the draft tray, and that no more than 50 draft sheets are loaded. Ensure the draft tray has been fully inserted into its slot. Clean the draft sheet rollers.
What to do if nothing happens after clicking the OK button in the Print dialog box for my Brother Stampcreator PRO SC2000USB Label Maker?
Delete the print job, turn the SC-2000USB off, then on again, and try printing again.
What to do if the draft sheet is not fed out after the stamp is engraved (the xenon lamp flashed) by my Brother Stampcreator PRO SC2000USB Label Maker?
Check that the draft sheet feeds out automatically the next time that an ID label sheet or another draft sheet is printed.
What to do if the stamp could not be engraved with my Brother Label Maker?
Make sure that a stamp is inserted correctly and is the correct size. Check that the message 'INSTALL STAMP !' appears on the LCD display and that the printed draft sheet has stopped over the xenon lamp unit. Also, ensure the stamp compartment cover is closed so that it locks.
What to do if my Brother Stampcreator PRO SC2000USB displays 'REMOVE LABEL 1', 'REMOVE LABEL 2', or 'REMOVE LABEL 3'?
Turn off the SC-2000USB, then remove the jammed draft sheet or ID label sheet.
Why is my Brother Stampcreator PRO SC2000USB Label Maker feeding the draft sheet out before the message 'INSTALL STAMP !' is displayed?
Turn off the machine, wait a while, and then turn it back on to try engraving a stamp again.
Why are the printed characters blurred when using my Brother Label Maker?
Clean the print head.
What to do if the xenon lamp flashed, but the desired stamp could not be engraved using my Brother Stampcreator PRO SC2000USB Label Maker?
Check that the cap was removed from the stamp before it was inserted and that there is no dust on the protective film covering the surface of the stamp. Ensure that the clear plastic surface of the xenon lamp unit is not dirty and that the printed draft sheet stopped over the xenon lamp unit before trying to engrave a stamp. The lines in the layout may be too thin, the text may be too small, or the fill pattern may be too detailed. Replace the xenon lamp unit.
Why are some printed characters missing on my Brother Stampcreator PRO SC2000USB?
Clean the print head. Also, check that there is no slack or wrinkles in the ink ribbon. If there is dust, fingerprints, etc. on the draft sheet or ID label sheet, use a clean sheet.
Guides on creating stamp designs using P-touch Editor software.
Steps to properly install the ink ribbon cassette into the SC-2000USB printer.
Procedure for loading draft sheets and installing the draft tray into the SC-2000USB.
Procedure for cleaning the draft sheet rollers of the SC-2000USB.
Steps to clean the ID label rollers to ensure proper feeding.
General| Type | Label Maker |
|---|---|
| Model | SC2000USB |
| Connectivity | USB |
| Technology | Thermal Transfer |
| Display | LCD |
| Power Source | AC Adapter |
| Maximum Print Width | 24 mm |
| Label Types | Die-cut |
| Software Compatibility | Windows, Mac |
| Max. print height | 1.57 inches |
| Max. print width | 2.4 inches |
| Compatibility | Windows, Mac |
To Next Page