What to do if the stamp cannot be inserted into my Brother Label Maker?
Be sure to open the doors within the stamp compartment by pulling the lever toward you. Check that the cap, skirt, and grip were removed from the stamp before trying to insert it.
What to do if the stamp was engraved too much by my Brother Stampcreator PRO SC2000USB Label Maker?
The layout is too detailed.
What to do if the characters are not printed in the correct position by my Brother Stampcreator PRO SC2000USB?
Check that the ID label or stamp is the correct size.
What to do if the stamp was not engraved well enough by my Brother Stampcreator PRO SC2000USB Label Maker?
Check that the clear plastic surface of the xenon lamp unit is not dirty. Replace the xenon lamp unit.
General| Type | Label Maker |
|---|---|
| Model | SC2000USB |
| Connectivity | USB |
| Technology | Thermal Transfer |
| Display | LCD |
| Power Source | AC Adapter |
| Maximum Print Width | 24 mm |
| Label Types | Die-cut |
| Software Compatibility | Windows, Mac |
| Max. print height | 1.57 inches |
| Max. print width | 2.4 inches |
| Compatibility | Windows, Mac |
Guides on creating stamp designs using P-touch Editor software.
Steps to properly install the ink ribbon cassette into the SC-2000USB printer.
Procedure for loading draft sheets and installing the draft tray into the SC-2000USB.
Procedure for cleaning the draft sheet rollers of the SC-2000USB.
Steps to clean the ID label rollers to ensure proper feeding.
To Next Page