How to reset Brother TD4000ZU1 Label Maker and delete transferred data?
To reset your Brother Label Maker and delete the data transferred from your PC, first turn the machine OFF by pressing and holding the ON/OFF button. Then, hold down the ON/OFF button again for two seconds. While still holding the ON/OFF button, press the Cut button six times.
What to do if Brother Label Printer TD-4000/4100N does not print?
If your Brother TD-4000/4100N Label printer is not printing or you are receiving a printing error, try the following: * Ensure the cable is securely connected. * Remove and reinstall the RD Roll. * Check that enough roll remains. * Confirm that the RD Roll compartment cover is closed. * Turn the printer off and on again. If the problem persists, contact Brother Customer Service at 1-800-255-0415. * Move the guide against the side of the RD Roll. * Feed the media under the gap sensor.
What to do if the label is not ejected properly after printing Brother?
If labels are not ejected properly from your Brother Label Maker after printing, check the following: * Ensure the ejection path of the label is not blocked. * Remove and reinstall the RD Roll to ensure it is set properly. * Make sure the RD Roll compartment cover is closed properly.
How to fix cutter error on Brother TD4000ZU1?
To resolve a cutter error on your Brother Label Maker, keep the RD roll compartment cover closed and press the ON/OFF button.
How to improve print quality on Brother TD4000ZU1?
If the print quality of your Brother Label Maker is poor, clean the roller.
How to cancel printing job on Brother Label Maker?
To cancel a print job on the Brother Label Maker, ensure the printer is turned ON, and then press the ON/OFF button.
Why printed barcode cannot be read on Brother TD4000ZU1?
If the printed barcode from your Brother Label Maker cannot be read, try using a different scanner. It is also recommended to print the barcode with Print Quality options set to 'Give priority to quality'.
What to do if Status LED lamp is not lit on Brother TD4000ZU1 Label Maker?
If the Status LED lamp on your Brother Label Maker is not lit, check the following: * Ensure the power cord is plugged in. * If it is plugged in, try another electrical outlet. * Make sure the main power switch is turned on. If the power button still does not light up, contact Brother Customer Service at 1-800-255-0415.
What to do if data transmission error appears on the personal computer with Brother TD4000ZU1?
If you encounter a data transmission error on your personal computer while using the Brother Label Maker, verify that the correct port is chosen from the 'Print to the following port' list in the Printer Properties dialog box. Also, wait until the LED lamp stops flashing and then try printing again. You may also try executing the print job again after any other jobs are completed.
How to fix streaks or poor quality characters on Brother Label Maker?
If the printed label from your Brother Label Maker contains streaks or poor quality characters, or the label is not fed correctly, clean the roller.
General| Print Technology | Direct Thermal |
|---|---|
| Connectivity | USB, Serial, Ethernet |
| Resolution | 300 dpi |
| Cutter | Automatic |
| Max Print Width | 4.09 inches |
| Media Type | Labels |
| Maximum Label Length | 39.4 inches |
| Supported OS | Windows |
| Display | No |
To Next Page