How to fix BROVIND CFV when the display doesn't light up?
First, check that the power cable is properly connected to the mains. Next, open the controller box and ensure the power is correctly connected inside. Also, inspect the fuses on the board to see if they are in good condition. Finally, use a testing device to verify that power is reaching the switch on the controller box.
What to do if BROVIND CFV Controller shows a short-circuit at output?
Turn off the controller immediately and inspect the output for any short-circuits. If no shorts are found, attempt to turn the controller back on. Additionally, check if the vibrator speed was accidentally set to 0 for safety reasons (A0) and reset it.
Why is the vibrator not working on my BROVIND CFV Controller?
Make sure that all parameters are set correctly, including vibration amplitude, frequency, and the activation/deactivation of sensors. Also, verify that the vibrator is properly connected to the power board.
What does Supply voltage alarm mean on BROVIND CFV?
The supply voltage alarm activates if the supply voltage falls below 50 Volts or exceeds 300 Volts.
What to do if BROVIND CFV is stopped by a sensor?
Go to the menu for sensor 1 and/or sensor 2 and disable the sensor that is causing the issue.
How to reset BROVIND CFV Controller parameters to factory settings?
The factory-set parameters can be restored by selecting configuration 5 in the “Saving Work Configurations” menu (Menu 40).
What does SRV02 probe alarm mean on BROVIND CFV?
This alarm indicates that the probe is set but is not responding. It activates if, with A0 greater than 1.0, As stays at 0 for at least 20 seconds.
General| Brand | BROVIND |
|---|---|
| Model | CFV Series |
| Category | Controller |
| Language | English |
To Next Page
