System Set-Up
Global User Manual
2-9
System Set-Up
Mounting Parts
The following steps for mounting a workpiece to the work-
table are necessary to ensure an accessible and stable workpiece
during the measuring operation. The more accessible and stable
the workpiece, the more accurate the results.
· Remove all obstructions from the worktable’s surface.
· Clean the worktable surface with alcohol.
· Ensure the workpiece to be measured does not exceed the
workpiece capacity.
· Ensure the sections to be measured are within the measuring
range of the probe.
· Locate the workpiece as close as possible to the operator.
To Next Page
Loading...