Attaching Cutter
16
Before hitching cutter to your skid loader, make sure all safety devices are installed on both
the cutter and the skid loader.
Please follow all safety instructions and procedures.
Attach equipment to skid loader.
Be sure the skid loader is equipped with a certied roll-over protection
structure (ROPS), and an enclosed operator-protective cage to prevent hazards such
as thrown, falling, or stationary objects from entering the protective cage.
Be extremely careful when positioning skid loader to hitch to the equipment.
Caution Never allow anyone between the skid loader and the equipment during
the attachment process.
Be certain that the cutter bearing housing has been lubricated properly and check oil
level in bearing housing prior to connecting hydraulic hoses to skid loader.
Warning Improperly attached hydraulic lines will disconnect and may cause
personal injury or property damage.
STOP
To Next Page
Loading...