INSTALLATION INSTRUCTIONS
WARNING:
This item is heavy. All necessary
precautions should be taken when lifting
and assembling this fireplace.
Make certain the fireplace body always
remains upright. Do not lie on its side or
you could cause damage to the body.
Most parts of this fireplace are pre-assembled
before shipment. Please follow below assembly
instructions before you start to en
joy your
fireplace.
Step 1: Carefully unpack the product, and take
out all the components. Make sure you take out
all the packaging materials as well.
Step 2: Put the fireplace body in the final
position. It should only be put on a flat and
NON-COMBUSTIBLE floor, and there must be a
minimum of 24 inches of clearance from the
tabletop to COMBUSTIBLE walls. Make sure the
valve on the control panel is turned all the way
clockwise to the “OFF” position. (Figure 1)
Step 3: Put up the body (Figure 2), put up 1
pound gas tank’s adopter to connect valve
assembly tight it up by clockwise direction.
(Figure 3)
Now you’re ready to enjoy your pillar fireplace.
Follow the operation instructions when you’re
using this appliance
(Figure 1)
(Figure 2)
(Figure 3)
To Next Page