OPERATION INSTRUCTIONS
Lighting and Setting Control for Gas
Before lighting, make sure the valve knob is in the “OFF” position.
1. From the OFF position, push in and turn control knob anti-clockwise to the LOW position.
2. Always perform a leak test before lighting the burner. See page 4
3. Hold a lit match within 1/4” to the lava logs as shown on
below picture, until the burner is lit. If burner fails to
light, turn to OFF. Wait 5 minutes before attempting to re-light.
4. Turn control knob to desired heat setting, LOW or HIGH.
Shut-down for Gas
1. Turn the control knob gently to “OFF” position.
2. Disconnect and remove the gas tank when the gas fireplace is not in use.
MAINTENANCE INFORMATION
1. The flames should look like those in the figure below. Adjust the control knob to reach different height for flame.
2. If in raining day, burner should be turned off and store indoor.
3. It is recommended that the fireplace be stored indoors in freezing temperatures. The cylinder must be
disconnected and removed from the appliance before the appliance can be stored indoors.
4. The propane canister must be stored outdoors and never close to the operating unit.
To Next Page
Loading...