11
B. THE HELMET
7. SUN VISOR
REMOVING THE SUN VISOR
1. Turn the helmet face shield to the open
position.
2. Pivot the sun visor in the lower position.
3. Pull the sun visor downward until you
see the upper edge.
4. Hold your helmet in position and pull
the sun visor on the right side, toward the
outside of the helmet.
5. Repeat steps 3 - 4 for the other side.
The sun visor lever should remain in
the same position while you install the
visor.
INSTALLING THE SUN VISOR
1. Make sure the sun visor mechanism is in
low position. (Sun visor lever back)
2. Insert the sun visor between helmet
inner and outer shell and fit it on to the
locating pegs on both sides.
Then, press firmly towards the inside of the
helmet until the hook’s inner insert is
completely inserted.
3. Check that the sun visor mechanism is
functioning correctly.
To Next Page
Loading...
