BRP ADVEX - Noise Control System; Inner Liner

15
B. THE HELMET
11. NOISE CONTROL SYSTEM
Your helmet is equipped with noise reduction ear pads. You can adjust the
pads position to achieve the desired comfort by following the steps below:
• Place the helmet upside down in front of you so that the visor is pointing
downwards;
• Verify that the pads are correctly held in place by the Velcro;
• Put on your helmet as described in the “2. PROPER FIT” section of this
manual;
• Determine your ideal pad position;
• Take off and flip your helmet, and adjust
the pads as per previously determined
position.
• If needed, you can also add the provided
foams (3 mm thick) behind the pads to
adjust the thickness and get a better fit.
• Repeat as needed until desired comfort
is reached.
If you still feel too much pressure, you can completely remove the NCS
from the helmet. It will not affect the helmet performances as far as the fit
is correct except the noise reduction.
WARNING
Always be alert for sounds – Your helmet may impair your hearing.
Your helmet is not a form of hearing protection.
12. INNER LINER
The replaceable inner lining of the ADVEX helmet is washable and
ensures both an excellent fit and improved ventilation of the helmet.
The dual-density cheek pads have a specific 3D shape to ensure that the
helmet fits comfortably around the cheeks, and the headliner provides an
optimal fit all around the head.
All interior fittings are made entirely of skin-friendly material. The material
used for the cheek pads and head liner has been treated with an
antimicrobial treatment.
When removing the lining, the cheek pads must first be detached before
taking out the headliner pad. When fitting the lining, remember to insert the
headband pad before the cheek pads.
PAD SIZES
Helmet size
XS
S
M
L
XL
2XL
3XL
Cheek pad
thickness
35
mm
30
mm
25
mm
35
mm
35
mm
30
mm
20
mm
Head
liner
thickness
Top
16
mm
16
mm
16
mm
16
mm
12
mm
12
mm
12
mm
Crown
18
mm
16
mm
16
mm
18
mm
8
mm
6
mm
6
mm
TYPICAL