To Next PageTo Next Page
Need help?Do you have a question about the BRP Can-Am Spyder RS 2014 Series and is the answer not in the manual?
General| Brand | BRP |
|---|---|
| Model | Can-Am Spyder RS 2014 Series |
| Category | Motorcycle |
| Language | English |
Procedure for removing the protective cover from the vehicle crate.
Steps to remove parts and sub-crates from the main crate.
Ensuring all required parts are present in the crate.
Instructions for safely lifting the front of the vehicle from the crate.
Procedure for installing the front wheels onto the vehicle.
Steps to remove the vehicle from its shipping crate base.
Installation procedure for the front cargo module.
Procedure for activating and installing the vehicle battery.
Installing the Ambient Air Pressure and Temperature Sensor.
Connecting the wiring harness to the low beam headlights.
Connecting the horn wiring harness.
Installing the latch release cable for the front storage compartment.
Procedure for storing the diagnostic link cable.
Steps for installing various body panels and components.
Procedure for installing the front fenders on the vehicle.
Procedure for installing the rear fender onto the vehicle.
Information regarding hang tags and safety labels.
Procedure for installing the license plate on the vehicle.
General guidelines for checking and maintaining vehicle fluids.
Procedure for adding fuel to the vehicle's reservoir.
Specifications for the recommended type of fuel for the vehicle.
Details on recommended clutch fluid and its level verification.
Information on the recommended engine coolant and its properties.
Procedure to check the engine coolant level.
Details on recommended brake fluid and its level verification.
Information on recommended engine oil and oil level checking.
General guidelines for vehicle setup and adjustments.
Procedure for checking and setting tire pressure.
Procedure for checking and adjusting drive belt tension.
Procedure for adjusting the clutch lever position.
Instructions for adjusting headlight aim.
Procedure for programming vehicle settings using B.U.D.S. software.
Steps to enter customer name via B.U.D.S. software.
Procedure to reset trip hours and distances using B.U.D.S.
Procedure to change speedometer units (Metric/Imperial).
Procedure to set cluster language via B.U.D.S.
Steps to properly end a B.U.D.S. software session.
Setting cluster units and clock for base models.
Setting clock and language for models other than base.
Procedure for testing vehicle operation after assembly.
Instructions for cleaning the vehicle safely.
Final steps before delivering the vehicle to the customer.
